How are Type I indicating torque tools classified into Classes A–E?

Applies to: ISO 6789:2003, ISO 6789-1:2017 · Updated 2026-11-17

Technical review: Alston Hsiao (Chieh-Jen Hsiao), CTO, STAND

Key answer

First separate wrenches from screwdrivers, then look at the mechanism and the measurement method; that is how you find a Type I tool’s Class, A to E. This assumes you have already confirmed that the tool is an indicating torque tool. Having a display does not necessarily mean the tool uses electronic measurement, nor does it make the tool a setting torque tool.

Start from the tool in your hand

The Type I classification is the same in the 2003 edition and in ISO 6789-1:2017. The table below puts the tool form first, so you can cross-check the physical tool against its specification. The letters are only class codes; they are not a ranking of accuracy.

Tool form to identify firstFeature to confirm nextClass
WrenchIndicates the applied torque through a torsion bar or flexion bar mechanismI-A
Wrench with a rigid housingIndicates by a scale, dial, or display; must be distinguished from the electronic measurement classI-B
Wrench with a rigid housingSpecification confirms electronic measurementI-C
ScrewdriverIndicates by a scale, dial, or display; must be distinguished from the electronic measurement classI-D
ScrewdriverSpecification confirms electronic measurementI-E

I-A is shorthand for Type I, Class A, and so on for the others. When checking documents, keep both the Type and the Class so the tool is not confused with the Type II class that uses the same letter. If a tool looks different from common examples, go back to its mechanism and measuring function; do not decide the class by how closely it resembles a photograph.

A display is a reading interface; electronic measurement is a separate condition

The most common confusion is between B and C, and between D and E. The class descriptions already include a display for Classes B and D, while Classes C and E are characterized by electronic measurement. A catalog that only says “with display” therefore does not give enough information to choose C or E.

For example, faced with a rigid-housing indicating wrench that has a digital window, first find out what the window shows and how the torque is measured. Only if the documentation clearly states electronic measurement is there a basis for I-C. If it describes only the appearance, ask the manufacturer to supply the class and the operating principle. This is an identification scenario; it does not mean any actual product has been classified.

After classifying, check the range

Once you know the Class, you can look up the range and test requirements that apply in that edition. In ISO 6789-1:2017 in particular, indicating tools do not all determine the lower end of the range in the same way: Classes A, B, and D follow a different rule from Classes C and E.

The same classification does not mean the procedures in the two editions are identical. When receiving a tool or ordering calibration, it is advisable to record the standard edition, Type, Class, and the manufacturer’s description together. If the tool also has other functions, confirm the classification of those functions and the evidence for them. Establishing the tool’s identity first prevents the wrong conditions from being applied later.